Stirling Cycle header



Circa 1895 Rider-Ericsson Hot-Air Pumping Engine

Rider-Ericsson Hot-Air engine
Serial # 12704

click on the picture for a close view (146K jpg)

Click here for a view of the entire display rig.

Stirling Cycle, Water Pumping Engine manufactured by the
Rider-Ericsson Engine Co., New York, New York

6" Bore X 3" Stroke - Approx. 1/8 to 1/4 H.P. at 100 R.P.M.

This rare engine was used strictly to pump water, as its horse power was insufficient to do much of anything else. The engine was built to be placed next to a well or cistern with the pump suction pipe hanging down into the water. The water was then pumped up to a storage tank or possibly a water trough for animals. Before discharging the water from the engine, the water was passed through a water jacket at the upper end of the cylinder to provide the cooling required of the Stirling Cycle process. This 6" Rider-Ericsson, using 1" pipe on both the pump suction and discharge, was rated at 300 gallons (1136 l) per hour with a 50' (15m) rise (75' (23m) maximum). This engine weighs approximately 625 lbs. (283 kgs.)

Ericsson tag


Look under Model Engines to see a working 1/3 scale model of this Hot-Air engine.

R/E Building, Walden, New York circa 1870

back button home button